UPBK35 RF-Armor PowerBridge Kits for PBM3 and PBM5
UPBK35 - RF-Armor PowerBridge Kits for PBM3 and PBM5
Shielding designed for the Ubiquiti 3/5 GHz PowerBridge.
F
Lower noise floor
Cleaner signal
Superior signal to noise ratio
Less wireless retries and errors
Higher sustainable air rates
Up to 50% increase in performance
Reduce unwanted RF energy from the back, sides, top, and bottom outside the designed beam from reaching the antenna and radio keeping the radio focused on the intended signal.
Co locate several radios close together with out self interference and a much lower noise floor!
Increased performance and throughput.
UPBK35 - RF-Armor PowerBridge Kits for PBM3 and PBM5
Shielding designed for the Ubiquiti 3/5 GHz PowerBridge.
F
Lower noise floor
Cleaner signal
Superior signal to noise ratio
Less wireless retries and errors
Higher sustainable air rates
Up to 50% increase in performance
Reduce unwanted RF energy from the back, sides, top, and bottom outside the designed beam from reaching the antenna and radio keeping the radio focused on the intended signal.
Co locate several radios close together with out self interference and a much lower noise floor!
Increased performance and throughput.
The kit will NOT increase the gain of the antenna, however it will lower the noise floor providing a much cleaner signal allowing for higher sustainable air rates.
Made from marine grade aluminum.
(Powerbridge is not included in the kit)
- Device Features
- Outdoor
- Accessory Type
- Shield